Shop drawings and erection plans

Victorino Detailing Group, LLC prepares structural steel shop drawings, erection plans, piece marks, and bills of material from the design set.

Drawing standard

US customary structural shapes · Fractional inches, unless the job is metric · Drafted in AutoCAD 2024 LT

Drawings

Drawings

  • Shop drawings
  • Erection plans
  • Piece marks
  • Bills of material

Design set

Design set

  • Member sizes as designed
  • Connection criteria from the engineer
  • Project specifications
  • Fractional inches, unless the job is metric
Sheet set

What the drawings carry

Shop drawings and erection plans document the engineer’s design. They do not assign member sizes or design connections.

  • Shop drawings
  • Erection plans
  • Piece marks
  • Bills of material

Shop practice

Piece marks

Each main member carries the piece mark shown on the shop drawing.

Erection marks

Erection plans locate members on the grid given in the design set.

Bills of material

The bill lists the members drawn on the sheet. It does not assign new sizes.

Bolts and welds

Bolt and weld callouts follow the design. They are not a new connection design.

US customary

Shapes and dimensions are US customary, in fractional inches, unless the job is metric.

From the design set

Member sizes are taken from the engineer’s drawings. Missing sizes are flagged.

Open questions

Where the design set is silent, the sheet lists the question instead of guessing.

Second check

Marks, bolts, welds, and the bill are checked against the design set before issue.

Start a set

Drawings are prepared by Victorino Detailing Group, LLC from the design set you send. A phone number and an email address are not published on this page.

Read the scope
  • Current design drawings
  • Project specifications
  • The engineer’s connection criteria
  • Anchor-rod or embed layouts already issued

Issued from the design set

Victorino Detailing Group, LLC prepares structural steel shop drawings and erection plans in AutoCAD 2024 LT. Member sizes and connection design stay with the engineer of record.

Checked before issue

Piece marks

Main members carry the mark shown on the sheet.

Erection marks

Plans locate each member on the design grid.

Bolts and welds

Callouts follow the design and are not a redesigned connection.

Bill of material

Quantities follow the members drawn on the sheet.

The design set stays in charge.

Shop drawings, erection plans, piece marks, and bills of material record the design. They do not replace it.